PDA

View Full Version : Bersa 383da MAG Modification?



57offsuit
02-15-2015, 02:08 AM
So has anyone looked into getting their 383DA modified so that the newer thunder mags would fit?

After looking at both for a long time it looks like it can be done just may need a good vice grip and a dermal.
Make the mag cavity a hair slightly larger. there seems to be enough room to do it.


Thoughts?

pollyb
02-15-2015, 06:17 AM
So has anyone looked into getting their 383DA modified so that the newer thunder mags would fit?

Such a modification would be labor intensive and impractical.....the mag well would have to be machined in it's full lenght up the front to square(rounded corners) the front. I don't think such a proceedure could be done with a Dremel tool and would be difficult for a machinist.

Note: You could modify your model 97 mag with a new mag slot and remove the mag safety on your 383DA.

JM2 pennies

regards jab